2002 Honda Odyssey Knock Sensor Location

Where are knock sensors usually located?

Where is a Knock Sensor Located? A knock sensor is typically attached directly to the outside of the engine block, but in some cases, it is located underneath the intake manifold. via

What does the knock sensor do in a Honda?

The knock sensor detects abnormal combustion, known as spark knock, inside of the engine. Common causes of spark knock include low octane fuel, overly advanced ignition timing, abnormally high engine operating temperatures, and carbon buildup inside the engine's combustion chambers. via

Where is the bank 1 knock sensor?

The 'Bank 1' portion of the code indicates that the issue pertains to the knock sensor on the side of the engine that houses the number one cylinder. via

How do you fix the knock sensor code P0325?

  • Replacing the ECU.
  • Repairing or replacing the wiring harness.
  • Replacing a faulty knock sensor.
  • Repairing an electrical connection.
  • via

    What triggers a knock sensor?

    The knock sensor detects vibrations that come from a knock or an irregularity in combustion and send a signal to the engine control computer, which then adjusts timing to correct the knock. via

    Do you need to reset ECU after replacing knock sensor?

    If you have replaced the knock sensor, then defenitly reset your ECU. Once that is complete, you should have full power almost immediately. no nothing bad will happen from resetting your ecu. via

    Can knock sensors be turned off?

    There is no way to disable the knock sensors currently. If you unplug them or they don't see enough noise you'll get a 3100 limp. via

    Does a knock sensor affect performance?

    A bad knock sensor may also not let the engine accelerate properly while driving on the highway, and cause the vehicle to lose fuel mileage. If you notice these things happening, you should have a certified mechanic from YourMechanic inspect why the car is slow to accelerate. via

    How do I reset my ECU? (video)


    What is code P0328?

    What the P0328 code means. The P0328 code is telling us that there is a high input from the bank 1 knock sensor 1. The ECU detects excessively high voltage that is out of range of the knock sensor. This leads to the Check Engine Light being displayed on the dashboard. via

    Can a vacuum leak cause engine knock?

    Vacuum Leaks

    Vacuum leaks in any of these components may cause spark knocking or pinging. Check vacuum hoses in these systems (and intake manifold plenum gasket on some models) for damage and loose connections. Consult your vehicle repair manual to locate components. Check the knock sensor for proper operation. via

    What happens if you have a vacuum leak?

    Since a vacuum leak similarly lets air into the engine, the engine will respond by idling faster. When this happens, the car's computer will try to compensate, typically creating a sporadic or fluctuating idle speed. The engine stalls: In some cases, a vacuum leak can cause your engine to die or stall out. via

    How do you check a knock sensor on a Honda?

    1. With the knock sensor unplugged and using a digital volt ohmmeter (DVOM), check for 0.02V to 0.03V reference voltage from the ECM to the knock sensor. 2. Next use a scope and look for an AC voltage signal from the knock sensor when the engine rpm is increased. via

    How much is knock sensor?

    Most of the time, it is relatively simple to replace a knock sensor. The parts are between $60 – $80 and the labor is between 1-2 hours. This results in a total price for parts and labor between $151-$545 for most makes and models. via

    Leave a Comment