10 Mm Self Locking Nuts

What size is a M10 lock nut?

M10 (10mm) Thread Size. 17mm Nut Width A/F (J) [Max] 6.50mm Hexagon Height (T) [Min] via

Which nuts are self locking?

A locknut, also known as a lock nut, locking nut, self-locking nut, prevailing torque nut, stiff nut or elastic stop nut, is a nut that resists loosening under vibrations and torque. via

Are self locking nuts reusable?

Nuts are designed to wear faster than bolts. For self locking nuts, it is acceptable to reuse them as long as there is still some locking action. via

What are the two types of self locking nuts?

The most common lock nuts types are metal lock nuts and nylon insert lock nuts. via

How do you use a stop nut? (video)


How do you get a wheel off without locking the nut? (video)


How many times can you use a self-locking nut?

"Do not reuse self-locking nuts. These nuts are designed to be used only once and should be replaced whenever they are removed." Recently, I bought a book of Mr. Carroll Smith: "Nuts, Bolts, Fasteners and Plumbing", ISBN-13: 978-0-87938-406-7. via

How do you torque a self-locking nut?

When torquing a self-locking nut, the nut should be run down on the threads of the bolt until the nut almost contacts the mating surface. The amount of torque required to run the nut down (friction drag torque) should be measured and added to the amount of torque specified for the fastener. via

How many times can you use a nylon insert lock nut?

These are found in lower temperature applications, typically less than 177°C due to the polymers within the nylon lock nut. They provide desirable reusability and can be used assuredly up to fifteen times after an initial fastening. via

What is a Binx nut?

Binx Nuts are all metal, prevailing torque type self-locking nuts with the locking action provided by two slots cut into the side of the nut. The locking action of this locknut works on the diameter and the thread pitch, which counters loosening via stress or via vibrations. via

How do you identify a lock nut? (video)


How are locking nuts measured?

If you measured at 50mm the size is 50 divided by 5, this gives us an 10 sized lock nut , 30mm would give us an 6 sized lock nut (30/5=6). To measure a lock nut simply measure it's bore and then divide the measurement by 5. via

How do self-locking nuts work?

As the nut is threaded onto a shaft or rod, it will spin freely until the threads from the host part engage the nylon insert. The threads of the mating shaft will displace the nylon and create resistance. This resistance prevents unintentional moving of the lock nut. via

Do you need a lock washer with a lock nut?

Lock washers are used to keep the nut and bolt in place by preventing them from turning, slipping or coming loose. There are a wide variety of lock washers, each designed for a specific application, but their basic purpose is always the same – to keep the nut and bolt secure. via

How tight should a locking nut be?

Getting them off a journey when you have a flat could leave you stranded, so they should be nipped up a bit more than finger tight. If the locking nut comes loose, the other wheel nuts should be fully tightened and Torqued. via

Leave a Comment